Toro Super Recycler 20038, Руководство оператора

Страница: 18 / 24

18
Installing the Blade
1. Install a sharp, balanced Toro blade, an accelerator, a
lock washer, and the blade bolt (Fig. 20).
Note: The sail part of the blade must point upward
(toward the top of the housing).
2. Torque the blade bolt to 50 ft-lb (68 N m).
Operating the lawn mower without the accelerator
in place can cause the blade to flex, bend, or break,
resulting in serious injury or death to the operator
or bystanders.
Do not operate the lawn mower without the
accelerator.
Warning
3. Return the lawn mower to its upright position.
4. Connect the wire to the spark plug.
Adjusting the Self-propel Drive
Cable
Whenever you change the handle height, install a new
self-propel cable, or the traction drive belt slips, adjust the
self-propel drive cable.
1. Stop the engine and wait for all moving parts to stop.
2. Remove the cover (Fig. 23).
281
1
2
Figure 23
1. Belt cover 2. Bolts
3. Loosen the cable support nut (Fig. 24).
m-4205
1
2
3
4
Figure 24
1. Cable jacket
2. Cable support
3. Nut
4. Upper handle
4. Push the drive bracket down until it contacts the lawn
mower, then hold it in place (Fig. 25).
m-4273
1
2
Figure 25
1. Drive bracket 2. Push here
5. With the upper handle pushed back as far as possible
and while holding the drive bracket down, pull the cable
jacket down (toward the lawn mower) until there is no
slack in the cable (Fig. 24).
6. Tighten the nut on the cable support (Fig. 24).
7. Release the drive bracket.
8. Install the belt cover.
Lubricating the Self-propel
Drive
1. Wipe the grease fittings on the rear cutting height levers
with a clean rag (Fig. 26).
1
276
Figure 26
1. Grease fitting (2)