Toro Super Recycler 20038, Руководство оператора

Страница: 10 / 24

10
Using the Self-propel Drive
To operate the self-propel drive, simply walk forward with
your hands on the upper handle and your elbows at your
sides, and the lawn mower will automatically keep pace
with you. The faster you walk, the farther the handle will
slide and the faster the lawn mower will propel (Fig. 9).
m-4206
Figure 9
To slow down the drive, simply slow your walking speed;
to stop the drive, stop walking (Fig. 9).
Note: If, when backing up after self-propelling, the lawn
mower does not roll backward freely, nudge the lawn
mower forward about an inch without engaging the
self-propel drive, then pull the lawn mower backward.
Adjusting the Cutting Height
You can adjust each wheel individually with the wheel
height adjustment lever. Cutting heights are 1 inch
(25 mm); 1-1/2 inches (38 mm); 2 inches (51 mm);
2-1/2 inches (64 mm); and 3 inches (76 mm).
Danger
Adjusting the cutting height levers could bring
your hands into contact with a moving blade and
result in serious injury.
•
Stop the engine and wait for all movement to
stop before adjusting the cutting height.
•
Do not put fingers under the housing when
adjusting the cutting height.
1. To change the cutting height, pull the cutting height
lever toward the wheel and move it to the desired
position (Fig. 10).
788
1
A = 1 in. (25 mm)
B = 1-1/2 in. (38 mm)
C = 2 in. (51 mm)
D = 2-1/2 in. (64 mm)
E = 3 in. (76 mm)
Figure 10
1. Cutting height lever
2. Release the cutting height lever and seat it securely in
the notch.
Note: Set all 4 wheels at the same height.
Using the Grass Bag
Occasionally, you may want to use the grass bag for
bagging lush grass or collecting leaves.
Installing the Grass Bag
1. Stop the engine and wait for all moving parts to stop.
2. Ensure that the discharge door handle is fully forward
and that the pin is engaged in the catch (Fig. 11).
1912
1
3
2
Figure 11
1. Bag frame on retaining
post
2. Pin contacting latch plate
3. Handle fully forward
(discharge door closed)
3. Slide the hole in the bag frame onto the retaining post
on the discharge tunnel (Fig. 11).
4. Set the rear of the bag frame onto the lower handle.
5. Open the discharge door by pulling the discharge door
handle forward until the pin clears the ramp on the bag
door and moving the handle rearward until the pin locks
in the bag notch (Fig. 12).