Toro STX-26, Руководство оператора

Страница: 38 / 48

g007839
Figure 54
1. Filler-neck cap 2. Hydraulic-fluid filter
6. If the level is low, add fluid until it is visible in the
glass bubble.
7. Install the cap and filter on the filler neck and
torque bolt on top to 13 to 15.5 N∙m (110 to 140
in-lb).
8. Install the cover plate; refer to Removing the
Cover Plate (page 21) .
Changing the Hydraulic
Fluid
Service Interval: Every 400 hours/Yearly (whichever
comes first)
1. Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
hydraulic lift.
2. Shut off the engine and remove the key.
3. Allow the machine to cool completely.
4. Remove the top cover.
5. Remove the hydraulic-tank filler cap and filter
(
Figure 54 ).
6. Place a drain pan capable of holding 37.8 L (10
US gallons) under the hydraulic tank.
7. Pinch the hose clamp and slide the clamp and
hose off the fitting on the hydraulic tank, allowing
the hydraulic fluid to drain from the hose and
tank into the pan.
g007840
Figure 55
1. Hose
2. Hydraulic-tank fitting
3. Hose clamp
8. When finished, install the hose onto the fitting
and secure it with the hose clamp.
Note:
Dispose of the used oil at a certified
recycling center.
9. Fill the hydraulic tank with hydraulic fluid; refer
to
Hydraulic Fluid Specifications (page 37) .
10. Install the hydraulic filter and filler cap ( Figure
54 ) and torque the bolt on top to 13 to 15.5 N∙m
(110 to 140 in-lb).
11. Start the engine and let it run for a few minutes.
12. Shut off the engine.
13. Check the hydraulic-fluid level and top it off if
necessary; refer to
Checking the Hydraulic-Fluid
Level (page 37) .
14. Clean up any spilled fluid.
15. Install the top cover.
38