Toro Sitework Systems 22420, Руководство оператора

Страница: 5 / 12

Product Overview
Specifications
Note:
Specifications and design are subject to change
without notice.
Width 24 inches (61 cm)
Length 22 inches (56 cm)
Height 25 inches (63.5 cm)
Weight 120 lb (54 Kg)
Boring diameter 1.25 to 3.5 inches (3.2 to 8.9
cm)
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Operation
Refer to your traction unit Operator’s Manual for more
information on installing and removing attachments
on your traction unit.
Important:
Always use the traction unit to lift and
move the attachment.
Installing Accessories
Toro offers several different rods and bits for use with
the attachment. Purchase accessories from your Toro
dealer.
1. Stop the engine, wait for all moving parts to stop,
and remove the key.
2. Slide the hex shaft of a rod, boring bit, or reamer
into the socket. Align the hole in the socket with
the push button connector (Figure 2).
Figure 2
1. Accessory shaft 3. Push button connector
2. Socket 4. Hole
3. Press down the push button connector and push
the shaft into the socket until the connector snaps
into the hole in the socket (Figure 2).
4. Repeat steps 2 and 3.
Removing an Accessory
1. Stop the engine, wait for all moving parts to stop,
and remove the key.
2. Press the push button connector securing the
accessory shaft in the socket and pull the accessory
free of the socket.
5