Toro Sand Pro 2040Z, Руководство оператора

Страница: 14 / 60

1
Removing the Shipping Board
No Parts Required
Procedure
Before you can install an attachment on the machine, you
must remove the shipping board.
1. Remove the nuts, bolts, and washers securing the
shipping board to the rear of the machine (
Figure 3 ).
G023667
Figure 3
2. Discard the fasteners and the shipping board.
2
Installing an Attachment
Parts needed for this procedure:
–
Attachment and related parts (sold separately)
Procedure
WARNING
If you drive the machine without an attachment
installed, it can tip over and injure someone or
damage property.
Drive the machine only if there is an approved
attachment installed.
Refer to the attachment Installation Instructions for information
on installing the attachment.
3
Installing the Front Weights
Parts needed for this procedure:
–
Front weights (as needed per attachment)
Procedure
This machine has been designed in accordance with ANSI
B71.4-2012. However, when you install attachments on the
machine, you must add additional weight to the machine, as
specified, to comply to the standards.
Use the chart below to determine the additional weight
required. The machine comes with 4 weights. Each
attachment comes with the necessary additional weights, if
required.
Attachment Number of weights required
Flex tooth rake 4
Flex tooth rake with finish brush 6
Nail drag 6
Nail drag with finish drag mat 8
Refer to Installing and Removing the Weights (page 21) .
14