Toro Reelmaster 5510 Series, Руководство по обслуживанию

Страница: 540 / 662

Aftercut Appearance
There are a number of factors that can contribute to unsatisfactory quality of cut,
some of which may be turf conditions. The turf conditions such as excessive
thatch, sponginess, or attempting to cut off too much grass height may not
always be overcome by adjusting the cutting unit. It is important to remember
that the lower the height-of-cut, the more critical these factors are.
Refer to the Cutting Unit Operator’s Manual for detailed cutting unit adjustment
procedures. For cutting unit repair information, refer to Service and Repairs
(page 9–17) .
Note: For additional information regarding the cutting unit troubleshooting, refer
to Aftercut Appearance Troubleshooting Aid (Toro Part No. 00076SL) .
Factors That Can Affect Quality of Cut
Factor Possible Problem/Correction
Tire pressure Check the tire pressure of all the traction unit
tires. Adjust to the pressures specified in the
Operator’s Manual .
Governed engine speed For best cutting performance and appearance,
engine should be run at high-idle speed during
machine operation (use the InfoCenter display
to check the engine speed); refer to
Chapter 4:
Yanmar Diesel Engine (page 4–1) for high-idle
speed specification.
Reel speed All the cutting reels should rotate at the same
speed (within 100 rpm).
All the cutting units should have equal bedknife
to reel and height-of-cut adjustments.
Ensure that the reel speed selection is correct
(use the InfoCenter display to check and adjust
the reel speed).
Refer to the Traction Unit Operator’s Manual
for recommendations for reel speed settings.
Reel bearing condition Check the reel bearings for wear and replace
if necessary.
Refer to Reel Assembly in the Service and
Repairs section of this chapter.
Bedknife to reel adjustment All cutting units must have equal bedknife to
reel and height-of-cut adjustments.
Check the bedknife to reel contact daily. The
bedknife should have light contact across the
entire reel. No contact will dull the cutting
edges. Excessive contact accelerates wear of
both edges. Quality of cut is adversely affected
by both conditions; refer to Bedknife to Reel
Adjustment in the
Cutting Unit Operator’s
Manual .
Cutting Unit: Aftercut Appearance Page 9–10 Reelmaster ® 5410/5510/5610 Series
15216SL Rev C