Toro ProPass 200, Руководство по установке

Страница: 5 / 16

g013860
Figure 7
1. Hitch tube 2. Mounting bolts (2)
22. Adjust the engine mount bracket so that it is
tight to the hitch. Fully tighten the two bolts
securing the engine mount brackets to the
engine mounting plate (
Figure 8 ).
23. Check that the engine mounting plate is level
and fully tighten the 2 bolts (1/2 x 5 inches)
through the engine mount bracket lower holes.
24. Place the battery onto the battery tray,
positioning the terminals as shown in
Figure 8 .
25. Position the battery hold down on the battery
(
Figure 8 ).
26. Hold the battery mount strap around the
underside of the hitch tube (
Figure 8 ).
27. On the right side, install a battery bolt through
the washer, battery mount strap, engine mount
plate, battery tray and hold down. Loosely install
a flange nut (
Figure 8 ).
Note:
Make sure the bolts are installed from
the bottom.
28. On the left side, install a battery bolt through
the washer, battery mount strap, engine mount
plate, battery tray, battery bolt tube, and hold
down. Loosely install a flange nut (
Figure 8 ).
29. Make sure everything is concentric and tighten
the nuts
g013862
Figure 8
1. Battery bolt (2)
4. Battery mount strap
2. Washer (2) 5. Flange locknut (2)
3. Bolt tube
30. Unpack the hose guide, hydraulic return hose
(hose #3), hydraulic suction hose (hose #4), 4
bolts (1/4 x 3/4 inch) and 4 locknuts (1/4 inch).
Note:
Remove the hose secured to the hose
guide, hydraulic return hose and hydraulic
suction hose for shipping.
31. Using 2 bolts (1/4 x 3/4 inch) and flange
locknuts, attach the hose guide to the bracket
on the hydraulic tank (
Figure 9 ).
5