Toro procore sr54, Руководство оператора

Страница: 15 / 40

Note:
Cut off more of the inside tube if it
protrudes into the cross and bearing section of
the outer tube.
g237888
Figure 18
g237889
Figure 19
14. Using the dimensions determined in step 11,
locate, mark and cut off just the safety shields to
expose the tubes (
Figure 20 and Figure 21 ).
g237890
Figure 20
g237891
Figure 21
15. Carefully remove any burrs from the ends of the
tubes with a file and remove all the filings from
the tubes.
16. Grease the inside tube.
Note:
The telescoping tubes must always
overlap by 1/2 of their length during normal
operation and at least 1/3 of their length during
all working conditions. During transport, when
the drive line is not rotating, the telescoping
tubes must have a suitable overlap to maintain
alignment of the tubes and allow them to slide
freely.
9
Installing the PTO Shield
Parts needed for this procedure:
1 PTO shield
Procedure
1. Remove the 4 bolts, lock washers, and flat
washers secured to the rear of the aerator
gearbox (
Figure 22 ).
g010849
Figure 22
1. PTO shield 4. Bolt
2. Flat washer 5. Access panel
3. Lock washer
2. Mount the PTO shield to the aerator gearbox
with the fasteners previously removed (
Figure
22 ).
Align the access panel ( Figure 22 ) of the PTO
shield to the top or the side depending on the
aerator frame configuration.
15