Toro Powerlite 38274, Руководство оператора

Страница: 18 / 108

Note:
To determine the proper oil level on the
dipstick, refer to Figure 23 .
g013824
Figure 23
1. The oil level is at its
maximum. 3. The oil level is too
low—add oil to the
crankcase.
2. The oil level is too
high—remove oil from
the crankcase.
Note:
You may tip the machine forward (handle
up) a little to make adding oil easier. Remember
to return the machine to the operating position
before checking the oil level.
Important:
Do not tip the machine all the
way forward onto its nose, or fuel may leak
out of the machine.
Use Figure 24 to select the best oil viscosity for
the outdoor temperature range expected:
g011606
Figure 24
9. Wait 3 minutes for the oil to settle in the engine.
10. Wipe the dipstick clean with a clean cloth.
11. With the machine in the operating position,
insert the dipstick into the oil-fill tube,
but do not
screw it in , then remove the dipstick.
12. Read the oil level on the dipstick.
•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into
the oil-fill tube, wait 3 minutes, and repeat
steps
10 through 12 until the oil level on the
dipstick is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
13. Install the dipstick into the oil-fill tube securely.
14. Recycle the used oil properly.
Servicing the Spark Plug
Service Interval: Yearly—Service the spark plug and
replace it if necessary.
Use a Toro spark plug (Part No. 119-1961).
1. Shut off the engine and wait for all moving parts
to stop.
2. Disconnect the wire from the spark plug ( Figure
9 ).
3. Clean around the spark plug.
4. Remove the spark plug from the cylinder head.
Important:
Replace a cracked, fouled, or
dirty spark plug. Do not clean the electrodes
because grit entering the cylinder can
damage the engine.
5. Set the gap on the plug to 0.76 mm (0.030 inch)
as shown in
Figure 25 .
g000533
Figure 25
1. Center-electrode insulator 3. Air gap (not to scale)
2. Side electrode
6. Install the spark plug and torque it to 27 to 30
N∙m (20 to 22 ft-lb).
7. Connect the wire to the spark plug.
16