5.
Make certain everyone is clear of the machine
before starting the engine to move the Workman~
vehicle or to engage the Spreader drive.
6.
If equipment begins to vibrate abnormally, stop
immediately. Disengage all power end wait until all
moving parts have stopped. Repair all damage
before commencing operation.
MAINTENANCE
7.
Before servicing or making any adjustments to the
Toro Spreader:
A. Stop the Workman
®
vehicle and set the parking
brake.
B. Shut off the vehicle's engine and remove the
key from the ignition.
C. Disengage all power and wait until all moving
parts have stopped.
D. Do not touch the engine, muffler or muffler
shield while the engine is running or soon after
it has stopped, because these areas may be hot
enough to cause burns.
E. Keep hands, feet and clothing away from all
power-driven parts.
8.
Keep all nuts, bolts and other fasteners tightened
securely. Replace any shields removed during ser-
vicing or adjustments.
9.
To be sure of optimum performance and safety,
always purchase genuine TORO replacement parts
and accessories. Replacement parts and accessories
made by other manufacturer could be dangerous.
Altering this equipment in any manner may affect
the machine's operation, performance, durability or
its use may result in injury or death. Such use could
void the product warranty of the TORO Company.
CONTROLS
The PA-17 spreader is operational either with or without
the optional flow control kit (Model #41 403)
The controls listed below apply in either situation.
ELECTRIC CLUTCH SWITCH:
is the ON/OFF con-
trol for the spreader drive. Put the toggle switch at “ON”
to engage the spreader's agitator and spout mechanisms.
Put the toggle switch at “OFF” to disengage the mecha-
nism and stop the Agitator and Spout action.
Figure 1
1.
Electric clutch switch
2. Indicator
light
FLOW REGULATOR HANDLE:
Is used as an indica-
tor on the regulator scale of the rate of material flow. See
Fig. 2.
Fig. 2
1.
Flow regulator handle
2. Regulator
scale
3. Stop
pin
2
Содержание PA-17
Страница 8: ......
