Toro Multi Pro ExcelaRate 5800-G, Руководство оператора

Страница: 56 / 88

8. Install the cover onto the air-cleaner body and
secure the cover with the 2 latches (
Figure 67 ).
Note:
Ensure that the dust valve is aligned
between the 5 to 7 o’clock position when viewed
from the end (
Figure 67 ).
9. Align the coolant-overflow tank to the
tank-support bracket and seat the tank firmly
(
Figure 67 ).
Important:
Ensure that the pressure-relief
hose is routed forward and down, and the
tank-vent hose is routed rearward as shown
in
Figure 67 .
10. Lower the passenger seat.
Servicing the Engine Oil
Service Interval: After the first 50 hours—Change
the engine oil and oil filter.
Every 200 hours—Change the engine oil
(including synthetic oil) and oil filter. Change
the oil and filter more often when operating
the machine under heavy load or in high
temperatures.
Every 400 hours/Yearly (whichever comes
first)—Complete all yearly maintenance
procedures specified in the
engine operator's
manual.
Crankcase oil capacity: 5.1 L (5.4 US qt) with the
filter.
•
Oil type: API service classification SL or higher.
•
Oil viscosity: refer to the engine oil viscosity
table below.
Engine Oil Viscosity Table
Ambient temperature range
Oil viscosity
Above 25°C (77°F) SAE30, SAE10W-30, or
SAE15W-40
0°C to 25°C (32°F to 77°F) SAE20 or SAE10W-30
0°C to 20°C (32°F to -4°F) SAE10W or SAE10W-30
Toro Premium Engine Oil is available from your
distributor in either 15W40 or 10W30 viscosity. Refer
to the
Parts Catalog for part numbers.
Checking the Engine Oil
Service Interval: Before each use or daily Check the
engine oil level before you start the
engine for the first time.
Note:
The best time to check the engine oil is when
the engine is cool, before it has been started for the
day. If it has already ran, allow the oil to drain back
down to the sump for at least 10 minutes before
checking.
The engine is shipped with oil in the crankcase;
however, the level of oil must be checked before you
first start the engine and after you have run it.
1. Position the machine on a level surface.
2. Remove the dipstick, located under the
passenger seat, and wipe it with a clean rag
(
Figure 68 ).
Note:
Insert the dipstick into the tube and make
sure it is seated fully. Remove the dipstick and
check the oil level.
g028335
g028343
Figure 68
1. Front of the machine
3. Dip stick
2. Oil-filler cap
3. If the oil level is low, remove the filler cap from
the valve cover (
Figure 68 ) and pour oil into the
filler neck until the oil level is up to the Full mark
on the dipstick.
Note:
Add the oil slowly and check the level
often during this process. Do not overfill.
4. Install the oil-filler cap ( Figure 68 ).
5. Install the dipstick firmly in place ( Figure 68 ).
56