Toro LX466, Руководство оператора, Страница: 25 / 64

25
NOTE:
Models with a 46-inch deck and manual PTO
are equipped with a short cable which controls the deck
spindle brake. It is necessary to unhook this cable in
order to fully remove the cutting deck from the tractor.
Be certain to reattach the cable when re-mounting the
cutting deck.
10. Gently slide the cutting deck toward the front of the
tractor allowing the hooks on the deck to release
themselves from the deck stabilizer rod.
11. For models with manual pto, remove the hairpin clip
that secures the PTO cable to the rear of the cutting
deck. See Figure 21. Remove the PTO cable and
accompanying spring from the cutting deck.
12. Gently slide the cutting deck (from the left side) out
from underneath the tractor.
Changing the Upper Deck Belt
WARNING:
Be sure to shut the engine off,
engage the parking brake and remove the
ignition key to prevent unintended starting
before removing the belt.
WARNING:
Avoid the possibility of a
pinching injury. Do not place your fingers on
the idler spring or between the belt and a
pulley while removing the belt.
All belts on your tractor are subject to wear and should
be replaced if any signs of wear are present.
IMPORTANT:
The V-belts found on your tractor are
specially designed to engage and disengage safely. A
substitute (non-OEM) V-belt can be dangerous by not
disengaging completely. For a proper working machine,
use factory approved belts.
To change or replace the upper deck belt on your
tractor, proceed as follows:
1. Remove the cutting deck.
2. Remove the belt covers by removing the screws
that fasten them to the deck.
3. Loosen, but do not remove the deck idler pulleys.
4. Remove the deck belt from around all pulleys,
including the deck idler pulleys.
5. Route the new belt as shown in the figure below and
retighten the deck idler pulleys.
6. Reinstall the belt guards removed earlier and
remount the deck to the tractor.
NOTE:
Several components must be removed and
special tools used in order to change the lower deck
belt. See your dealer to have this belt replaced.
Figure 23
Idler Pulleys
Belt Cover