Toro LX466, Руководство оператора

Страница: 11 / 64

11
Attaching The Seat
If the seat for your tractor did not come attached, follow
the instructions below to attach it.
1. Remove the two knobs from the bottom of seat.
2. Position the shoulder screws (found on the base of
the seat) inside the slot openings in the seat pivot
bracket.
3. Slide the seat slightly rearward in the seat pivot
bracket, lining up the rear slots in the pivot bracket
with the remaining two holes in the seat’s base.
4. Select desired position for the seat, and secure with
the two knobs removed earlier. See Figure 3.
Figure 3
Attaching the PTO Lever
NOTE:
Your tractor’s PTO lever may have already
been attached at the factory.
Tools Required
(1) 1/2" socket wrench
1. Position the PTO lever on the PTO shaft and
secure with the hex lock nut. See .
Figure 4
2. Place the PTO lever cap over the hex nut and push
downward until it “clicks” into place.
Shipping Brace Removal
WARNING:
Make sure the riding mower’s
engine is off, set the parking brake and
remove the ignition key before removing the
shipping brace
.
• Locate the shipping brace, if present, and warning
tag found on the right side of the cutting deck. See
Figure 5.
• While holding the discharge chute with your left
hand, remove the shipping brace with your right
hand by grasping it between your thumb and index
finger and rotating it clockwise.
Figure 5
WARNING: T
he shipping brace, used for
packaging purposes only, must be removed
and discarded before operating your riding
mower.
WARNING:
The mowing deck is capable of
throwing objects. Failure to operate the riding
mower without the discharge cover in the
proper operating position could result in
serious personal injury and/or property
damage.
Knobs
Shoulde r Sc r ews
PTO Leve r
Hex Nut
Cap
PTO
Shaft