Toro Groundsmaster 3500 30807, Руководство по обслуживанию

Страница: 27 / 283

Groundsmaster 3500−D Page 3 − 7 Kubota Diesel Engine
Check Air Filter, Dust Cup, & Burp Valve
The air cleaner body, air filter, dust cup, and burp valve
should be checked daily, prior to operation.
IMPORTANT: Any leaks in the air cleaner system
will cause serious engine damage. Make sure that
all air cleaner components are in good condition
and are properly secured during operation.
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch. Unlatch and raise hood.
2. Check air cleaner body for damage that could cause
possible air leaks. Make sure dust cup seals completely
to the air cleaner body (Fig. 3).
3. Check burp valve and dust cup for damage.
4. Make sure air hoses connecting the air cleaner to the
engine and radiator are secured tightly and free of pos-
sible air leaks.
Figure 3
1. Latch
2. Dust
cup
3. Burp valve
2
1
3
Muffler Removal
CAUTION
The muffler and exhaust pipe may be hot. To
avoid possible burns, allow the engine and ex-
haust system to cool before working on the muf-
fler.
Figure 4
1. Flange head nut
2. Flange head screw 3. Muffler plate
4. Muffler bracket
4
2
1
3
1. Park machine on a level surface, lower cutting units,
stop engine, engage parking brake, and remove key
from the ignition switch.
2. Open engine hood to gain access to engine.
3. Remove exhaust guard.
4. Remove both flange head nuts and screws securing
the muffler plate to the muffler bracket (Fig. 4).
5. Remove four hex nuts and lock washers from the ex-
haust manifold studs. Separate muffler flange from the
exhaust manifold. Remove muffler from the machine.
6. Remove exhaust gasket. Replace gasket if dam-
aged or torn.
Muffler Installation
NOTE: Make sure muffler flange and exhaust manifold
sealing surfaces are free of debris or damage that may
prevent a tight seal.
1. Place exhaust gasket on the exhaust manifold.
IMPORTANT: Finger tighten all fasteners before se-
curing the muffler plate to the muffler bracket so
there is no preload on the exhaust manifold.
2. Position muffler flange to the exhaust manifold with
four lock washers and hex nuts.
3. Position muffler plate to the muffler bracket with both
flange head screws and nuts (Fig. 4).
4. Tighten muffler flange hex nuts and then muffler
plate screws and nuts.
5. Install exhaust guard.
6. Close and latch engine hood.
Safety
Product Records
Kubota
Diesel Engine
Hydraulic
Electrical
Wheels, Brakes,