Toro Groundsmaster 3500 30807, Руководство по обслуживанию

Страница: 236 / 283

Groundsmaster 3500 Page 7 - 6 Wheels, Brakes, and Chassis
Adjust Rear Lift Arm
NOTE: If rear lift arm makes clunking noises during
transport, the clearance should be adjusted/reduced.
1. Park machine on a level surface and engage parking
brake.
IMPORTANT: This adjustment must be performed
with the rear cutting unit attached to the rear lift arm.
2. Raise lift arms. Make sure clearance between one
end of wear strip and bumper bar on frame is from .020
to .100 inch (0.51 to 2.54 mm) when other end of wear
strip is in contact with bumper bar (Fig. 8).
3. If the clearance is not in this range, attain proper
clearance by adjusting the rear hydraulic cylinder as fol-
lows (Fig. 9):
A. Lower cutting units, turn engine off, and remove
key from the ignition switch.
B. Back off jam nut from the rear hydraulic cylinder
clevis.
IMPORTANT: Use a protective covering around the
hydraulic cylinder rod when rotating the rod to pre-
vent damage to the rod.
C. Grasp cylinder rod near the jam nut and rotate the
rod.
D. Raise cutting units and check clearance. Repeat
steps A through C as necessary. Tighten jam nut on
hydraulic cylinder rod when clearance is correct.
IMPORTANT: The lack of clearance at the rear wear
strip can damage the rear lift arm.
1. Wear strip 2. Bumper bar
Figure 8
2
1
1. Rear hydraulic cylinder 2. Jam nut
Figure 9
2
1