Toro Greenmaster Flex 04044, Руководство оператора

Страница: 37 / 40

g027790
Figure 50
1. Jam nuts 3. Reel-control cable
2. Traction-control cable
4. At the control-handle bulkhead, tighten the
reel-control cable enough to remove the slack
from the cable without extending the spring.
5. Check the operation as follows:
•
Verify that the reel-clutch teeth disengage
when the clutch is released and the
reel-clutch teeth do not bottom out when
engaged.
Note:
Remove the rubber plug ( Figure 46 )
from the hole in the front of the transmission
to view reel clutch.
•
The reel stopping time must be less than 7
seconds with the reel to bedknife backed off.
•
Refer to the Service Manual or contact
your authorized Toro distributor for further
assistance.
Storage
Storage Safety
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Allow the engine to cool before storing the machine
in any enclosure.
Storing the Machine
1. Remove any grass clippings, dirt, and grime
from the external parts of the entire machine,
especially the engine. Clean the dirt and chaff
from the outside of the engine cylinder-head fins
and the blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
shift-lever plate and the engine.
2. For long-term storage (more than 30 days) add
stabilizer/conditioner additive to the fuel in the
tank.
A. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
B. Either shut off the engine, allow it to cool,
and drain the fuel tank, or operate the
engine until it shuts off.
C. Start the engine and run it until it shuts
off. Start the engine again, with the choke
closed, until the engine will not start.
D. Disconnect the spark-plug wire from the
spark plug.
E. Dispose of the fuel properly. Recycle it
according to local codes.
Note:
Do not store stabilizer/conditioned
gasoline over 90 days.
3. Check and tighten all bolts, nuts, and screws.
Repair or replace any part that is worn or
damaged.
4. Paint all scratched or bare metal surfaces. Paint
is available from your authorized Toro distributor.
5. Store the machine in a clean, dry garage or
storage area. Cover the machine to protect it
and keep it clean.
37