Toro Greenmaster Flex 04044, Руководство оператора, Страница: 36 / 40

Controls System
Maintenance
Adjusting the Traction
Control
If the traction control does not engage or if it slips
during operation, an adjustment is necessary.
1. Move the traction control to the E
NGAGED
position.
2. Measure the distance from the pin on either
end of the traction-control spring (
Figure 48 ); if
it is not within 7.3 to 7.6 cm (2-7/8 to 3 inches),
adjust the clutch according to the steps below.
g032417
Figure 48
1. Measure this distance
(should be 7.3 to 7.6 cm
(2-7/8 to 3 inches). 4. Turnbuckle
2. Traction-control spring 5. Jam nut
3. Clevis pin
A. Disengage the traction-control lever.
B. Loosen the jam nut on the turnbuckle and
remove the clevis pin, disconnecting the
spring from the turnbuckle (
Figure 48 ).
C. Turn the turnbuckle in or out to adjust the
length as necessary.
D. Install the turnbuckle to the spring with the
clevis pin.
E. Move the traction control to the E
NGAGED
position.
F. Measure the distance from the pin on either
end of the traction-control spring (
Figure
48 ); repeat steps A through F until it is
within 7.3 to 7.6 cm (2-7/8 to 3 inches).
Adjusting the Reel Control
If the reel control does not properly engage, an
adjustment is necessary.
1. Ensure that the reel control is disengaged.
2. At the transmission bulkhead, adjust the
reel-control cable (
Figure 49 ) to attain a spring
length of 70.6 to 72.4 mm (2.78 to 2.85 inches).
g017020
Figure 49
1. Reel-control cable 2. Jam nuts
3. At the control-handle bulkhead, loosen the
reel-control cable until there is slack in the cable
(
Figure 50 ).
36