Toro Greenmaster Flex 04044, Руководство оператора, Страница: 16 / 40

Kickstand
The kickstand ( Figure 23 ) is mounted to the rear of
the machine. Use the kickstand when you install or
remove the transport wheels or the cutting unit.
•
To use the kickstand to install the transport wheels,
lower the kickstand to the ground and step down
on the loop while pulling up and back on the
lower-center handle (
Figure 22 ).
CAUTION
The machine is heavy and can cause back
strain if lifted improperly.
Put your foot pressure down on the
kickstand loop and use only the
lower-center handle to raise the machine.
Attempting to raise the machine onto the
kickstand any other way can cause injury.
g018793
Figure 22
1. Lower-center handle 2. Kickstand loop
g239955
Figure 23
1. Kickstand 2. Kickstand loop
•
To prevent the machine from tipping backward
when removing the reel, lower the kickstand and
push in the locking pin to lock it in the S
ERVICE
position ( Figure 24 ).
g018142
Figure 24
1. Kickstand—S
TORAGE
position
3. Kickstand—S
ERVICE
position
2. Locking pin
16