Pilot Valve Operation (Electric Models Only)
The pilot valve controls the operation of the main valve located in the
100 PSI
(7.0 kg/cm
2
)
80 PSI
(5.6 kg/cm
2
)
65 PSI
(4.6 kg/cm
2
)
50 PSI (3.5 kg/cm
2
)
Figure 11
base of the sprinkler body. The main valve is operated by the release
of water metered through the pilot valve when it is activated either
manually at the sprinkler or by the irrigation system controller.
Another important function of the pilot valve is to regulate the water
pressure to the sprinkler nozzle. Pressure regulation compensates
for large variations within the system and maintains a constant
pressure for optimum sprinkler operation. The pilot valve is factory
set to regulate one of four pressure levels: 50 psi (3.5 bar), 65 psi
(4.6 bar), 80 psi (5.6 bar) or 100 PSI (7.0 bar).
Change the pilot valve operating pressure by loosening the thumb
screw that secures the selector lever. Position the selector lever to
the desired operating pressure and hand-tighten the nut.
See Figure 11.
Troubleshooting
Possible equipment failures with causes and corrective action are listed below.
Sprinkler won’t rotate
– Debris wedged between stator and turbine
• Remove obstruction
– Drive assembly defective
• Replace drive assembly
– Nozzle base assembly defective
• Replace riser assembly
Head sticks up
– Dirt in riser assembly
• Flush out. (See Flushing Sprinklers)
– Damaged or missing return spring
• Replace
– Damaged riser
• Replace
Poor distribution pattern
– Nozzle plugged with debris
• Clean or replace nozzle
– Nozzle orifice damaged
• Replace nozzle
– Low operating pressure
• Determine why system overloaded and correct
Valve won’t close (Electric)
– Continuous 24 VAC to sprinkler
• Check controller for voltage source
– Debris in Pilot Valve
• Disassemble and remove all debris
– Leak in pilot valve assembly
• Replace pilot valve assembly
– Plugged supply screen on piston
• Clean or replace screen
– Manual control selector on pilot valve assembly turned to “ON” position
• Turn to “AUTO” position
– Plunger movement restricted
• Inspect and clean or replace
– Valve cylinder misaligned with sprinkler body communication tube
• Remove valve assembly and install correctly
– Foreign object keeping valve from seating
• Remove, clean and check valve for damage. Replace if necessary
