Toro CM-1258Y-SD, Руководство оператора

Страница: 32 / 40

Removing and Installing
the Engine
Removing the Engine
1. Open the rear cowl; refer to Opening the Cowl
(page 19) .
2. Remove the 4 nuts and bolts that secure the
engine to the engine-mounting plate (
Figure 38 ).
g020391
Figure 38
1. Nuts and bolts
3. Slide the engine to the right, and move the drive
chain away from the engine sprocket.
4. Carefully lift the engine up and off the
engine-mounting plate.
Installing the Engine
1. Set the engine on the engine-mounting plate,
and align the bolt holes (
Figure 38 ).
2. Install the 4 bolts and secure them with the nuts
torqued to 24 N-m (18 ft-lb).
3. Check the drive chain tension, and adjust it if
necessary; refer to
Checking the Drive Chain
Tension (page 34) and Adjusting the Drive Chain
Tension (page 34) .
4. Close the rear cowl; refer to Closing the Cowl
(page 19) .
Fuel System
Maintenance
Servicing the Fuel System
Cleaning the Inlet-Fuel Screen
Service Interval: Every 50 hours—Clean the inlet-fuel
screen.
1. Clean the area around the fuel cap.
2. Remove the fuel cap.
3. Lift the inlet-fuel screen out of the fuel tank.
g021309
Figure 39
1. Fuel cap 3. Fuel tank
2. Inlet-fuel screen
4. Clean the inlet-fuel screen or replace it if it is
damaged.
5. Install the inlet-fuel screen.
6. Install the fuel cap and hand tighten it.
Note:
Overtightening the fuel cap will damage
it.
32