Toro 79413, Руководство оператора

Страница: 5 / 20

1
Preparing the Machine
No Parts Required
Procedure
1. Park the machine on a level surface.
2. Disengage the blade-control switch.
3. Move the motion-control levers outward to the
NEUTRAL
-
LOCK
position to engage the parking
brake.
4. Shut off the engine and remove the key.
2
Installing the Weights
Parts needed for this procedure:
4 Bolt (3/8 x 1 inch)
6 Locknut (3/8 inch)
1 Left weight-mounting bracket
1 Right weight-mounting bracket
2 Washer
2 Bolt (5/8 x 2-3/4 inches)
6 Suitcase weight
Procedure
Note:
This procedure is only for models with control
levers. Steering wheel models do not need weights
installed.
CAUTION
The bagger changes the weight distribution of
the machine. Operating the machine without
the front weights may cause an unstable
condition, which could result in a loss of
control.
Ensure the front weights are properly installed
before operating the machine with the bagger
attachment.
1. Install the weight-mounting brackets to the under
side of the frame using 2 bolts (3/8 x 1 inch),
and 2 locknuts (3/8 inch) as shown in
Figure 3 .
2. Install the suitcase weights to the weight
mounting brackets using 2 bolts (5/8 x 2-3/4
inches), 2 washers, and 2 locknuts (3/8 inch)
as shown in
Figure 4 .
3. Once you have installed all the weights and
brackets, ensure that all the fasteners are tight.
Tighten as necessary.
Important:
Whenever you remove the
bagger attachment, remember to remove the
front weights to return the proper stability
to the machine.
g299192
Figure 3
Castor fork and wheel not shown for clarity.
1. Front right caster 4. Right mounting bracket
2. Forward hole (right side
shown) 5. Bolts (3/8 x 1 inch)
3. Locknut (3/8 inch)
5