7
3
2
1
4
m-4871
Figure 5
1.
Pin
2.
Push arm
3.
Flat washer 1-1/2 in.
(38 mm)
4.
Retaining ring
Installing Lift Springs
1. Secure spring end plate assembly to traction unit with a
shoulder bolt (3/8 x 7/8 in. (23 mm)) and locknut
(3/8 in.) (Fig. 6).
1
m-3209
3
2
Figure 6
1.
Spring Assembly
2.
Shoulder Bolt, 3/8 x 7/8
in. (22 mm)
3.
Locknut, 3/8 in.
Reverse Gage Wheels
1. Remove hairpin cotter and pin to remove gage wheel
from on mower mount (Fig. 7). Slide gage wheel out of
mount and reverse location.
2. Select a hole position so the gage wheel is 3/8 in.
(9.5 mm) off the ground for the height-of-cut to be used
(Fig. 7).
3. Insert pin and secure with hairpin cotter.
4. Repeat adjustment on other gage wheel(s).
m–3197
1
2
3
Figure 7
1.
Wheel
2.
Pin
3.
Hair pin Cotter
Installing Mower
1. Position carrier frame in front of traction unit and place
push arms into clevises (Fig. 8).
2. Retain push arms with pivot pin assemblies, aligned
with flat against frame, and secure with hairpin cotters
(Fig. 8).
Note: Pivot pin assemblies and hairpin cotters are part of
traction unit.
2
4
3
m-4870
1
Figure 8
1.
Clevis
2.
Push Arm
3.
Pivot Pin Assembly–flat
4.
Hairpin Cotter
3. Lift carrier frame into vertical position, refer to: Tilting
the Mower.
4. Secure spring end plate assembly to carrier frame with
3/8 x 7/8 in. (23 mm) shoulder bolt and 3/8 in. locknut
(Fig. 9).
