Toro 74504TE, Руководство оператора, Страница: 39 / 64

Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks and
flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity) to prevent battery damage when
the temperature is below 0°C (32°F).
1. Remove the battery from the chassis; refer to Removing
the Battery (page 37) .
2. Check the electrolyte level.
3. Ensure that the filler caps are installed on the battery.
4. Charge the battery for 1 hour at 25 to 30 A or 6 hours
at 4 to 6 A.
5. When the battery is fully charged, unplug the charger
from the electrical outlet, and disconnect the charger
leads from the battery posts (
Figure 48 ).
6. Install the battery onto the machine and connect the
battery cables; refer to
Installing the Battery (page 38) .
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
Figure 48
1. Positive battery post 3. Red (+) charger lead
2. Negative battery post 4. Black (-) charger lead
Servicing the Fuses
The electrical system is protected by fuses and requires no
maintenance. If a fuse blows, check the component or circuit
for a malfunction or short.
1. Release the cushion from the rear of the machine.
2. Pull out the fuse to remove or replace it ( Figure 49 ).
3. Install the cushion to the rear of the machine.
Note:
Ensure that the correct-size fuse is installed
Figure 49 .
Figure 49
1. Ignition fuse—15 A 3. Power takeoff (PTO)
fuse—10 A
2. Accessory-port fuse—15
A 4. Infocenter fuse—7.5 A
39