Toro 74504TE, Руководство оператора, Страница: 29 / 64

Premaintenance
Procedures
Releasing the Cushion for
Rear Access
You can release the cushion for rear access to the machine for
maintenance or adjustment.
1. Lower the platform.
2. Loosen the twist knobs on each side of the machine
(
Figure 32 ).
Figure 32
1. Twist knob
2. Cushion
3. Remove the cushion and lower it to the platform.
4. Perform any maintenance or adjustment on the
machine.
5. Raise the cushion, and slide it onto the pins on both
sides of the machine.
6. Tighten the twist knobs.
Lubrication
1. Disengage the PTO and set the parking brake.
2. Shut off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag.
Note:
Make sure to scrape any paint off the front of
the fitting(s).
4. Connect a grease gun to the fitting.
5. Pump grease into the fittings until grease begins to
ooze out of the bearings.
6. Wipe up any excess grease.
Greasing the Front Caster
Pivots
Service Interval: Yearly
1. Remove the dust cap and adjust the caster pivots; refer
to
Adjusting the Caster-Pivot Bearing (page 41) .
Note:
Keep the dust cap off until you have finished
greasing the caster pivots.
2. Remove the hex plug.
3. Thread a grease fitting into the hole.
4. Pump grease into the fitting until it oozes out around
the top bearing.
5. Remove the grease fitting from the hole.
6. Install the hex plug and dust cap.
29