Toro 74216, Руководство оператора

Страница: 39 / 56

39
1
M-4640
2
3
Figure 52
1. Spring washers
2. Lock nut
3. Dust cap
Hydraulic System
Checking the Hydraulic Fluid
Check the hydraulic fluid level before engine is first
started.
Check the hydraulic fluid level after first 8 operating
hours.
Check the hydraulic fluid level after every 25 operating
hours.
Fluid Type: Mobil 1 15W-50 synthetic motor oil.
Important
Use only oil specified. Other fluids could
cause system damage.
System Capacity: 2.1 qt. (2.0 l)
1. Position machine on a level surface, stop the engine
and set the parking brake.
2. Clean area around filler neck of hydraulic tank
(Fig. 11).
3. Remove cap from filler neck. Look inside to check if
there is fluid in the reservoir. (Fig. 11).
4. If there is no fluid, add fluid to reservoir
approximately a 1/4 (6mm) below the top of baffle.
5. Run the machine 15 minutes to allow any air to purge
out of the system.
6. Recheck level while fluid is warm. Add fluid to raise
level to top of the baffle, if required.
Note: Fluid level should be to the top of the baffle when
fluid is warm (Fig. 11).
7. Install cap on filler neck.
2
1
3
M-4280
Figure 53
1. Cap
2. Baffle
3. Fluid level—full
Hydraulic fluid escaping under pressure can
penetrate skin and cause injury.
•
If hydraulic fluid is injected into the skin it
must be surgically removed within a few hours
by a doctor familiar with this type of injury.
Gangrene may result if this is not done.
•
Keep body and hands away from pin hole leaks
or nozzles that eject high pressure hydraulic
fluid.
•
Use cardboard or paper to find hydraulic leaks.
•
Safely relieve all pressure in the hydraulic
system before performing any work on the
hydraulic system.
•
Make sure all hydraulic fluid hoses and lines
are in good condition and all hydraulic
connections and fittings are tight before
applying pressure to hydraulic system.
Warning
Replacing the Hydraulic Filter
•
Change the hydraulic filter:
•
After the first 8 operating hours.
•
After every 200 operating hours.
•
Use summer filter above 32 F (0 C)
Use winter filter below 32 F (0 C)
1. Disengage the power take off (PTO) and turn the
ignition key to “OFF” to stop the engine. Move levers
to neutral locked position and apply parking brake.
Remove the key.
Important Do not substitute automotive oil filter or
severe hydraulic system damage may result.
2. Tilt seat forward to access filter.