30
MEASURE FROM
CUTTING EDGE TO A
LEVEL SURFACE
m–2539
Figure 32
2. Rotate the opposite ends of the blades forward.
Measure from a level surface to the cutting edge of the
blades at the same position as in step 1 above. The
difference between the dimensions obtained in steps 1
and 2 must not exceed 1/8
″
(3 mm). If this dimension
exceeds 1/8
″
(3 mm), the blade is bent and must be
replaced; refer to Removing the Blades and Installing
the Blades, page 30.
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
•
Always replace bent or damaged blade with a
new blade.
•
Never file or create sharp notches in the edges
or surfaces of blade.
Warning
Removing the Blades
Blades must be replaced if a solid object is hit, if the blade
is out of balance or is bent. To ensure optimum
performance and continued safety conformance of the
machine, use genuine TORO replacement blades.
Replacement blades made by other manufacturers may
result in non-conformance with safety standards.
Contact with sharp blade can cause serious injury.
Wear gloves or wrap sharp edges of the blade
with a rag.
Warning
1. Hold the blade end using a rag or thickly-padded
glove. Remove the blade bolt, spring disk and blade
from the spindle shaft (Fig. 35).
Sharpening the Blades
When sharpening blade, pieces of blade could be
thrown and cause serious injury.
Wear proper eye protection when sharpening
blade.
Warning
1. Use a file to sharpen the cutting edge at both ends of
the blade (Fig. 33). Maintain the original angle. The
blade retains its balance if the same amount of
material is removed from both cutting edges.
1
m–1854
Figure 33
1.
Sharpen at original angle
2. Check the balance of the blade by putting it on a blade
balancer (Fig. 34). If the blade stays in a horizontal
position, the blade is balanced and can be used. If the
blade is not balanced, file some metal off the end of
the sail area only (Fig. 35). Repeat this procedure until
the blade is balanced.
1
2
m–1855
Figure 34
1.
Blade
2.
Balancer
Installing the Blades
1. Install the blade onto the spindle shaft (Fig. 35).
Important
The curved part of the blade must be
pointing upward toward the inside of the mower to ensure
proper cutting.
2. Install the spring disk and blade bolt. The spring disk
cone must be installed toward the bolt head. (Fig. 35).
Torque the blade bolt to 85–110 ft-lb
(115–150 N
m).
Содержание 74216
Страница 7: ...7 Slope Chart...
Страница 8: ...8...