Toro 51595, Руководство оператора

Страница: 6 / 16

6
1. Place the charger against the wall and mark the two
hole locations, through the top of the keyholes in the
charger.
2. Drill pilot holes as follows:
•
If installing the charger on wall board, plaster, or
cement, drill two holes for the wall anchors (as
indicated by the wall anchor manufacturer) at the
marked locations.
•
If installing the charger on wood, drill two holes,
slightly smaller than the diameter of the screw
threads, at the marked locations.
3. If installing the charger on wall board, plaster, or
cement, insert the two wall anchors into the holes
(Fig. 4).
4. Hold the charger against the wall and drive the screws
into the wall anchors or holes (Fig. 4).
m–4092
2
1
3
Figure 4
1. Wall anchors
2. Screws
3. Charger
Operation
IMPORTANT: Before using your trimmer, read the
Important Safety Instructions in the Safety section;
refer to page 3.
Features
Compare the features illustrated in Figure 5 with your
trimmer to familiarize yourself with it.
7
m–4091
2
3
4
5
6
1
Figure 5
1. Battery compartment
2. Rear handle
3. Lock–off button
4. Front handle
5. Guard
6. Blade
7. Trigger
Battery
The battery powers the trimmer.
Handles
Use the front and rear handles to hold the trimmer during
operation.
Lock-off Button
The lock-off button reduces the possibility of accidental
starting. You must press the lock–off button before you
can squeeze the trigger. The lock–off button resets each
time the trigger is released.
Trigger
To turn on the trimmer, press and hold the lock-off button,
squeeze the trigger, then release the lock-off button.
Release the trigger to turn off the trimmer.
WARNING
POTENTIAL HAZARD
•
If the trigger is pressed, the trimmer will be
running.
WHAT CAN HAPPEN
•
Accidental starting of your trimmer could
result in serious personal injury.
HOW TO AVOID THE HAZARD
•
Only squeeze the trigger when you have both
hands on the handles and are ready to operate
the trimmer.