Toro 51557, Руководство оператора

Страница: 16 / 76

EN–5
Assembly
Note: Always turn off unit and unplug
from electrical outlet before adding or
switching attachments.
Blower
1. Slide tube onto blower outlet until tabs on tube
snap into latch (Fig. 2).
Note: Inlet cover must be securely locked
into position, activating interlock
switch, before blower will operate.
Pointer on cover will be aligned with
pointer on housing when cover is
correctly locked in position
(Fig. 3 & 4).
Note: Blower is shipped with inlet cover
installed.
Vacuum
1. Grasp inlet cover and rotate it counterclockwise
to remove (Fig. 5).
POTENTIAL HAZARD
•
Motor impeller rotates for a few seconds
after blower is turned off.
WHAT CAN HAPPEN
•
Rotating impeller can cut or injure fingers.
HOW TO AVOID THE HAZARD
•
Never remove inlet cover when motor is
operating or when unit is plugged in.
2. Hold vacuum tubes vertically and place blower
inlet over top of tube (Fig. 6). Tubes will only fit
one way in blower inlet.
3. Rotate unit clockwise until pointer on vacuum
tube aligns with pointer on housing
(Fig. 7, 8 & 9).
Note: Vacuum tube and housing pointers
must be aligned at locked position
before blower will operate.
4. Slide bag collar into bag opening until bag collar
flange is past the Velcro
strap (Fig. 10). Line
up bag seam with tab on collar. Tighten Velcro
strap to secure bag to collar (Fig. 10). Close bag
zipper. Bag should appear as shown in Figure 11
when correctly assembled.
5. Slide bag collar onto blower outlet until tabs on
bag collar snap into latch (Fig. 12).