Toro 44536, Руководство оператора

Страница: 12 / 16

Maintenance
Note:
Determine the left and right sides of the machine
from the normal operating position.
Greasing the Machine
The machine has grease fittings that you must lubricate
regularly with No. 2 lithium grease.
Fan-Shaft Bearings
Grease the 2 fan shaft bearings after every 8 hours of
operation ( Figure 10 ).
Note:
Remove belt cover to access rear fitting.
Figure 10
Caster Wheels
Grease the 2 drive-shaft fittings after every 100 hours of use
( Figure 11 ).
Figure 11
Drive Shaft
Grease the 2 drive-shaft fittings after every 100 hours of use
( Figure 12 ).
Figure 12
Adjusting the Blower Belt
Ensure that the belt is properly tensioned to ensure proper
operation of the machine and unnecessary wear. Check the
belt frequently.
Note:
Check and/or adjust the blower-belt tension after the
first 20 hours of operation.
Important:
The fasteners on the covers of this machine
are designed to remain on the cover after removal.
Loosen all of the fasteners on each cover a few turns
so that the cover is loose but still attached, then go
back and loosen them until the cover comes free. This
prevents you from accidentally stripping the bolts free
of the retainers.
1. Remove the capscrews, washers, and nuts securing the
belt guard to the blower housing (
Figure 13 ).
Note:
The drive shaft does not have to be
disconnected to adjust the belt.
Figure 13
1. Belt guard
2. Remove the belt guard ( Figure 13 ).
12