35
Storage
1.
Thoroughly clean the sweeper so it is free of dirt, leaves
and debris.
2.
Inflate tires to 22 psi.
3.
Check all fasteners. Tighten as necessary.
4.
Grease all grease fittings. Wipe off excess lubricant.
5.
Drain and replace hydraulic fluid and filter. Inspect all
hydraulic lines and fittings. Replace if necessary. Refer
to the Maintenance section.
6.
Check the tension and condition of the reel belts. Adjust
the tension if necessary.
7.
Check the condition of the rubber fingers. Replace any
broken, missing, or worn fingers.
8.
Service the battery and cables as follows:
A. Remove the battery terminals from the battery posts.
B. Clean the battery, terminals and posts with a wire
brush and baking soda solution.
C. Coat the cable terminals and battery posts with
Grafo 112X skin over grease (TORO Part Number
505–46), or petroleum jelly to prevent corrosion.
D. Slowly recharge the battery every 60 days for 24
hours to prevent lead sulfating of the battery.
Engine
1.
Drain the engine oil from the crankcase and replace
drain plug.
2.
Remove and discard the oil filter. Install a new oil filter.
3.
Refill crankcase pan with 2.1 quarts (2 liters) of SG or
SH, 10W–30 motor oil.
4.
Start the engine and run at idle speed for approximately
two minutes.
5.
Stop the engine.
6.
Thoroughly drain all fuel from the fuel tank, lines and
the fuel filter.
7.
Flush the fuel tank with fresh,clean gasoline.
8.
Re–secure all fuel system fittings.
Содержание 44044
Страница 31: ...31 Hydraulic Schematic...
Страница 32: ...32 Electrical Schematic...