Toro 41622, Руководство по установке

Страница: 7 / 20

Figure 8
1. Back plate assembly 7. Handle
2. Hair pin 8. Bolt (3/8 x 1–1/4 inches)
3. Flat washer 9. Right cradle arm
4. Bushing 10. Main support frame
assembly
5. Pivot pin 11. Cradle arm axle
6. Jam nut (3/8 inch) 12. Pivot housing
A. Start by installing the right cradle arm to the
frame. The right cradle arm is denoted by have
the long axle.
B. Insert the axle through the hinge shaft.
C. Loosely mate the left arm to the exposed axle on
the other side of the frame.
D. Install a bushing into the outside hinge holes of
the back plate assembly.
E. Move the back plate assembly into position
between the upper holes in each arm.
F. Install a pivot pin through the upper hole in the
arm and the hinge hole with the bushing in the
back plate assembly.
G. Install the handles to the lower holes in the arms.
Secure with a bolt (3/8 x 1-1/4 inches) and jam
nut (3/8 inch).
H. Repeat for the opposing arm.
I. Install a set screw to the left arm at the lower
hinge point (
Figure 9 ). Do not tighten at this time
to allow for adjustment of the cradle system.
Figure 9
1. Cradle arm, left 3. Set screw
2. Pivot housing 4. Holes in the cradle arm
7