Toro 41245, Руководство оператора

Страница: 5 / 12

3
Installing the Switch Box and
Hose Reel
Parts needed for this procedure:
1 Wiring harness
1 Switch box
1 Swivel plate
2 Bolt (5/6 inch)
2 Flange nut (5/16 inch)
1 Thrust washer
1 Snap ring
1 Hose reel
1 Spray-gun bracket
2 Carriage bolt
2 Flange nut (5/16 inch)
4 Short bolt (3/8 inch)
4
Small washer
4 Flange nut (3/8 inch)
1 Spring pin
1 Large washer
Procedure
1. Route the wiring harness up through the hole in the
bottom of the switch box.
2. Moving down the wiring harness, connect the harness
to the rate switch, the hose-reel button, and the power
relay (
Figure 4 ).
Note:
The fuse for the hose-reel motor is located in
the switch box.
Figure 4
1. Hose-reel button 3. Rate switch
2. Fuse 4. Power relay
3. Drop the swivel plate into the hole on the hose-reel
base.
4. On the underside of the hose-reel frame, attach the
thrust washer and snap ring to the post on the swivel
plate (
Figure 5 ).
Figure 5
1. Thrust washer 2. Snap ring
5. Mount the switch box to the swivel plate using 2 bolts
(5/16 inch) and 2 flange nuts (5/16 inch) as shown in
Figure 6 .
Figure 6
1. Swivel plate 3. Wiring harness
2. Switch box
4. Wiring-harness clip
6. Secure the wiring harness to the sides of the swivel
plate using the existing clips (
Figure 6 ).
7. Secure the hose reel to the swivel plate using 4 short
bolts (3/8 inch), 4 small washers, and 4 flange nuts
(3/8 inch) as shown in
Figure 7 .
Note:
The hose-reel motor should face away from
the switch panel.
5