Toro 41245, Руководство оператора

Страница: 4 / 12

1
Preparing the Machine
No Parts Required
Procedure
1. Ensure that the machine is empty of all fluids.
Note:
If chemicals have been used in the machine,
flush the system thoroughly with clean water; refer to
your vehicle
Operator's Manual for instructions.
2. Park the machine on a flat area, set the parking brake,
stop the pump, stop the engine, and remove the
ignition key.
3. Disconnect the terminal of the negative battery cable
from the battery.
2
Installing the Hose-Reel Frame
Parts needed for this procedure:
2 Hose-reel frame
4 Shoulder bolt
4 Flange nut (5/16 inch)
2 Bolt (5/16 inch)
2 Jam nut
1 Hose-reel base
4 Long bolt (3/8 inch)
4 Flange nut (3/8 inch)
Procedure
1. Mount the 2 hose-reel frames to the side of the
machine using 4 shoulder bolts and 4 flange nuts (5/16
inch) as shown in
Figure 2 .
Figure 2
1. Shoulder bolt 3. Flange nut (5/16 inch)
2. Bolt (5/16 inch) 4. Hose-reel frames
2. Secure the underside of the hose-reel frames to the
machine using 2 bolts (5/16 inch) and 2 jam nuts
(
Figure 2 ).
3. Lower the hose-reel base onto the hose-reel frames,
and secure them with 4 long bolts (3/8 inch) and 4
flange nuts (3/8 inch) as shown in
Figure 3 .
Figure 3
1. Hose-reel base
3. Flange nut (3/8 inch)
2. Long bolt (3/8 inch)
4