Toro 405500000, Руководство оператора, Страница: 9 / 36

Engine Controls
Oil Alert System
The oil alert system is designed to prevent engine
damage caused by an insufficient amount of oil in
the crankcase. Before the oil level in the crankcase
can fall below a safe limit, the oil alert system will
automatically shut off the engine (the engine switch
will remain in the O
N
position). If the engine stops
and will not restart, check the engine-oil level before
troubleshooting in other areas.
Choke Lever
The choke lever ( Figure 5 ) is required when starting a
cold engine. Before pulling on the recoil start handle,
move the choke lever to the C
LOSED
position. Once
the engine is running, move the choke lever to the
O
PEN
position. Do not use the choke if the engine is
already warmed up or the air temperature is high.
g020538
Figure 5
1. Recoil starter 4. Throttle lever
2. Fuel shut-off valve 5. On/Off switch
3. Choke lever
Throttle Lever
The throttle lever ( Figure 5 ) controls the speed (rpm)
of the engine. It is located next to the choke lever.
It sets the engine rpm and therefore can increase
and decrease the speed of the machine. For best
performance, set the throttle lever to the F
AST
position.
Fuel-Shutoff Valve
The fuel-shutoff valve ( Figure 5 ) controls the flow of
fuel from the fuel tank to the carburetor. The valve
is located underneath the choke lever. Move the
shutoff valve to the On position before attempting to
start the engine. Once you have finished using the
machine and you have turned the engine off, move
the fuel-shutoff valve to the Off position.
On/Off Switch
The On/Off switch ( Figure 5 ) allows the engine to start
and also stops the engine. This switch is located on
the front of the engine. The On/Off switch is marked
as follows:
•
l (On)—the ignition system is on.
•
O (Off)—the ignition system is off.
Note:
To start the machine, you must first move this
control to the O
N
position. When you want to shut off
the engine, move this switch to the O
FF
position.
Recoil Starter Handle
To start the engine, pull on the recoil starter handle
(
Figure 5 ) quickly to turn the engine over. The engine
controls described in Figure 5 must all be set correctly
for the engine to start.
Specifications
Note:
Specifications and design are subject to
change without notice.
Width (single wheel) 86 cm (34 inches)
Width (double wheel) 117 cm (46 inches)
Length 268 cm (105.5 inches)
Height 114.3 cm (45 inches)
Weight 621 kg (1370 lb)
Hopper capacity .45 m 3 (16 cu.ft.)
Maximum load 1136 kg (2500 lb)
Maximum load (single
wheel) 850 kg (1875 lb)
Wheelbase 107 cm (42 inches)
Discharge Height 16.5 cm (6.5 inches)
9