Toro 39519, Руководство оператора

Страница: 38 / 60

1. Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
2. Remove the console pad; refer to Removing the
Console Pad (page 28) .
3. At the battery, lift the black terminal cover on the
negative cable (
Figure 38 ).
g025881
Figure 38
1. Flanged bolt 5. Negative (-) battery
terminal
2. Terminal cover
(black—negative-battery
terminal) 6. Flanged nut
3. Terminal cover
(red—positive-battery
terminal) 7. Battery tray
4. Positive (+) battery
terminal 8. Battery strap
4. Disconnect the negative battery cable from the
negative (-) battery terminal, and remove the
cable from the battery (
Figure 38 ).
5. Slide the red terminal cover off the positive
battery terminal (
Figure 38 ).
6. Disconnect the positive (red) battery cable, and
remove the cable from the battery (
Figure 38 ).
7. Remove the hook of the battery strap from the
battery tray (
Figure 38 ), and remove the battery.
Installing the Battery
1. Place the battery onto the machine ( Figure 38 ).
2. Secure the battery to the battery tray with the
battery strap.
3. Install the positive (red) battery cable to positive
(+) battery terminal with a flanged bolt and
flanged nut (
Figure 38 ).
4. Slide the red terminal cover over the
positive-battery terminal.
5. Install the negative battery cable and the ground
wire to the negative (-) battery terminal with a
flanged bolt and flanged nut (
Figure 38 ).
6. Slide the black terminal cover over the
negative-battery terminal.
Charging the Battery
WARNING
Charging the battery produces gasses that
can explode.
Never smoke near the battery and keep sparks
and flames away from battery.
Important:
Always keep the battery fully charged
(1.265 specific gravity) to prevent battery damage
when the temperature is below 32°F (0°C).
1. Remove the battery from the chassis; refer to
Removing the Battery (page 37) .
2. Check the electrolyte level.
3. Ensure that the filler caps are installed on the
battery.
4. Charge the battery for 1 hour at 25 to 30 amps
or 6 hours at 4 to 6 amps.
5. When the battery is fully charged, unplug the
charger from the electrical outlet, and disconnect
the charger leads from the battery posts (
Figure
39 ).
6. Install the battery onto the machine and connect
the battery cables; refer to
Installing the Battery
(page 38) .
Note:
Do not run the machine with the battery
disconnected; electrical damage may occur.
g000538
Figure 39
1. Positive battery post 3. Red (+) charger lead
2. Negative battery post 4. Black (-) charger lead
38