Toro 38820, Руководство оператора

Страница: 6 / 32

1
Installing the Upper Handle
Parts needed for this procedure:
4 Handle bolts
4 Curved washers
4 Locknuts
Procedure
Note:
Do not remove the rubber band on the cables until
you have installed the upper handle.
1. Lift and rotate the upper handle and position it over
the lower handle (
Figure 3 ).
Important:
Route the cables attached to the
Quick Stick inside the upper handle legs and
ensure that the cables and the wire for the
headlight are not pinched between the handle
sections.
Figure 3
1. Cables
2. Secure the upper handle with 4 handle bolts, 4 curved
washers, and 4 locknuts from the loose parts bag
(
Figure 4 ).
Figure 4
2
Installing the Wheel Clutch
Cable Ends
No Parts Required
Procedure
1. Unwrap the cable ends from the lower handle ( Figure
5 ).
Figure 5
2. Route either the left or right cable end over the lower
handle and insert the cable end into the hole in the
corresponding wheel clutch lever (
Figure 6 ).
6