Toro 31526, Руководство по установке

Страница: 16 / 20

WARNING
Incorrect battery cable routing could
damage the machine and cables causing
sparks. Sparks can cause the battery
gasses to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
5. Connect the negative battery cable to the
negative post of the battery; refer to the
Operator’s Manual for your machine.
6. Close the right toolbox cover and install the right
console cover (
Figure 1 ).
7. Start the machine and allow the hydraulic
system to pressurize.
8. Stop the engine and check the hydraulic tubes,
hoses, and fittings for leaks.
Note:
Repair all leaks before operating the
machine.
Testing the Flow-Divider Manifold
1. Place the key into the switch, turn the key to the
O
N
position, and disengage the parking brake.
2. Drive the machine forward and press the 4WD
toggle switch forward.
Note:
You should hear the solenoids shift if the
kit is installed properly. If you do not, check the
wire harness connections and fuse placement.
3. Make a tight turn with the switch pressed
forward.
Note:
You should feel the 4WD if the kit is
installed properly. If you do not, check the wire
harness connections and fuse placement.
Operation
4WD Switch
Press and hold the 4WD toggle switch forward to
momentarily activate the 4WD function of the machine.
g035443
Figure 30
1. 4WD active 2. Normal position
Operating Tips
The flow divider kit enhances the traction drive
performance in compromised operating conditions.
Important:
If both the front and rear wheels spin,
feather the steering brake to control the transfer
of the torque from the spinning wheels to the
opposite front wheel.
16