Toro 31526, Руководство по установке

Страница: 12 / 20

4
Installing the Switch
Parts needed for this procedure:
1 Toggle switch
1 Wire harness
1
4WD function decal
Procedure
1. Drill a 13 mm (1/2 inch) hole in the center
console; refer to
Figure 20 for the appropriate
orientation.
Important:
Use caution to not hit any
components or wires underneath the
console with the drill bit.
g034559
Figure 20
1. 13 mm (1/2 inch) diameter 3. 25 mm (1 inch)
2. 13 mm (1/2 inch) from
the center of hole to the
right edge of the high-low
speed control switch
2. Place the 4WD function decal over the drilled
hole (
Figure 21 ).
g205310
Figure 21
3. Identify the switch terminal locations, wire
harness labels, and wire harness colors (
Figure
22 ).
The switch terminals are identified by the
numbers imprinted into the bottom of the switch.
Note:
The switch is spring-loaded to the rear of
the switch ( Figure 23 ). The switch is normally
open between terminals 1 and 2 ( Figure 22 ).
g273505
Figure 22
Installed switch orientation
1. Terminal 1—rear
3. Terminal 3—front
2. Terminal 2—center
12