Toro 31353, Руководство по установке, Страница: 5 / 8

3
Installing the Electrical
Connections
Parts needed for this procedure:
1 Solenoid
2 Bolt (1/4 x 3/4 inch)
1 Fuse holder
1 Jumper strap
1 Fuse
2 Flange nut (8 mm)
2 Flange nut (5/16 inch)
1 Red insulator
Procedure
Note:
Install these parts only when you install optional
electrical accessories for the 2 post ROPS extension kit.
1. Turn the battery-disconnect switch to the O
FF
position.
2. Using the slots in the bracket, push the fuse-holder
tabs into the bracket.
3. Install the solenoid to the bracket with 2 bolts (1/4
x 3/4 inch).
4. Install the red insulator onto the jumper strap ( Figure
5 ).
5. Install the jumper strap onto the fuse-holder right post
(
Figure 5 ).
6. Install the double-red wire connector onto the
fuse-holder left post (
Figure 5 ).
7. Install the fuse to the fuse holder and secure it with
2 nuts (8 mm).
8. Install the jumper strap to the right post of the solenoid
with a flange nut (5/16 inch).
9. Slide the red insulator over the jumper strap ( Figure
5 and Figure 6 ).
5