
12.
Install the front lights onto the front left and right
braces (
).
Note:
Use the existing nuts from the road lights.
g036256
1 2
1
3
4
Figure 1
1.
Front road lights
3.
Bracket on the front brace
2.
Discard the existing
bracket and hardware.
4.
Use a cable tie for the
harness.
13.
Reuse the hardware that you removed earlier to install
the turn indicators to the ROPS post (
14.
Install the upper left and lower left post covers onto
the left brace with 7 rivets.
Note:
Ensure that you install and secure all of the
accessories to the machine before you install the covers.
15.
Install the upper right and lower right post covers onto
the right brace with 7 rivets.
16.
Install the sunshade onto the frame with 4 hex-head
flange bolts (1/4 x 1 inch), sealing washers, and clips.
17.
Install the fuse cover plate to the rear roof mount with
thumbscrew knobs, retainer nuts, and speed nuts.
18.
Install the push-in fasteners in the left and right braces.
19.
Install the 2 plastic plugs and the 2 panel plugs into the
front roof mount (
).
20.
If needed, route the lead from the main harness to
the front and under the ROPS post for the rear lights
(
g036403
1
2
3
4
Figure 2
1.
Cable tie
3.
Route the harness to the
front.
2.
Lead from the main
harness.
4.
Ensure that the harness is
not pinched.
21.
Secure the harness with cable ties as shown in
1
g036258
Figure 3
1.
Cable-tie locations
3