4
Specifications
Note: Specifications and design subject to change without
notice.
General Specifications
Chamber Construction
Welded 7 GA (.1793 in.),10 GA (.1345 in.) and 12 GA (.1036 in.) steel. Spindle
support is 3/16 in. high-strength steel and 10 GA exterior channels, withstands
multiple blade impact tests. Deck frame is welded 1-1/2 in. square tubing and 7 GA
(.1793 in.) side supports, protects chamber, withstands collisions.
Blade
27” long, angled sail, heat treated steel
Tip Speed
15,400 ft./min. nominal
Blade Plane
(factory pre-set)
Height of Cut
2.00 (5.08 cm)
Right or left side
2.15 (5.46 cm)
Side to side
within .03 in. (.08 cm) of each other
Blade rake
approximately 5/16 in. (.79 cm)
Height of Cut
3/4–4 in. (1.91–10.16 cm) in 1/4 in. (.64 cm) increments
Deck Drive
Hydraulic, closed loop, integrated relief. High efficiency gear type pump. High
efficiency gear type motor. Recommended oil is Mobil DTE 15M (Mobil EAL
biodegradable compatible).
Spindles
1-1/4 in. (3.17 cm) shaft, greasable, tapered roller bearing, ductile iron housing
which withstands multiple impact tests.
Discharge
Rear, even clipping distribution in wet or dry conditions
Mulching Baffle (Optional)
Pre-drilled mounting holes provided in decks
Front Rollers
Two 5 in. (12.7 cm) diameter, ductile iron w/hollow core, sealed bearings, close
location to blade
Rear Roller
One 3 in. (7.6 cm) diameter, steel, sealed bearings, exterior shaft seal, full length,
close location to blade
Anti-Scalp Cup
6 in. (15.2 cm) standard
Suspension
Non-steering carrier frame
Weight
210 lb. (95 kg)
