Toro 30743, Руководство оператора

Страница: 8 / 16

8
The traction unit or broom may need to be moved slightly
to allow the PTO shafts to be coupled.
Note:
The PTO shafts will only align and insert in one
position.
5. Have a helper carefully push down on left hand push
arm until holes in ball joint mount are in line with holes
in broom mount.
Immediately slide 4 x 4 in. block of wood between top of
push arm and underside of chassis.
Make sure wooden block does not slip out
accidentally.
Warning
6. Attach ball joint mount to broom mount bracket with
spacer (100–5876) using the supplied capscrews, flat
washers and flange nuts.
7. Tighten all fasteners.
8. Remove 4 x 4 inch block.
9. Install broom lift chain.
10. Install arm lock brackets using 1/2” x 4” pins and
secure with retaining pins
11. Connect wire from control box to actuator plug.
(Option)
Pump Mounting
Important
The pump needs to be mounted differently
on traction units that have been equipped with different
cutting decks. If the pump is not mounted correctly the
PTO shaft could separate under some circumstances
Figure 2
1. Gm 300 with Side Discharge / Rear Discharge Deck
(8–1/2” of male spline)
Figure 3
1. Gm 300 with Recycler Cutting Deck
(6–3/4” of male spline)