Toro 30716, Руководство оператора

Страница: 8 / 24

8
Setup
Note: Determine the left and right sides of the machine from the normal operating position.
Loose Parts
Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description Qty. Use
Large castor wheel assembly
Small castor wheel assembly
2
2
Installing the castor wheels
Drive shaft
Capscrew, 5/16 x 1-3/4 in.
Locknut, 5/16 in.
Roll pin, 3/16 x 1-1/2 in.
1
2
2
2
Mounting the drive shaft
Capscrew, 7/16 x 3 in.
Flat washer, 7/16 in.
Flange nut, 7/16 in.
2
2
2
Connecting the right-hand push arm to the
cutting unit
Parts catalog 1
Operator’s manual 1 Read before operating the machine.
Installing the Castor Wheel
Assemblies
The thrust washers, spacers, and tensioning caps have been
installed on the castor wheel spindles for shipping.
1. Remove the tensioning caps from the spindle shafts and
slide the spacers and thrust washers off (Fig. 1 and 2).
2. Slide the spacers onto the castor spindle to get the
desired height-of-cut; refer to the Height-of-Cut Chart,
Page 12. Slide a thrust washer onto the spindle. Push
the large castor spindle through the front castor arm and
the small castor spindle through the rear castor arm.
Install another thrust washer and the remaining spacers
onto the spindle and install the tensioning cap to secure
the assembly (Fig. 1 and 2).
Important The thrust washers, not the spacers, must
contact the top and bottom of the castor arm.
1
2
2
4
3
Figure 1
1. Tensioning cap
2. Thrust washers
3. Spacers
4. Large (front) castor
spindle