Toro 30696, Руководство оператора

Страница: 39 / 48

2. Inspect the blades, especially the curved area
(Figure 45). If you notice any damage, wear, or
a slot forming in this area (item 3 in Figure 45),
immediately install a new blade.
Checking for Bent Blades
1. Rotate the blades until the ends face forward and
backward (Figure 46).
Figure 46
Figure 47
1. Measure from cutting edge to a level surface
2. Measure from a level surface to the cutting edge,
position A, of the blades (Figure 47). Note this
dimension.
3. Rotate the opposite ends of the blades forward.
4. Measure from a level surface to the cutting edge of
the blades at the same position as in step 1. The
difference between the dimensions obtained in steps
1 and 2 must not exceed 1/8 inch (3 mm). If this
dimension exceeds 1/8 inch (3 mm), the blade is
bent and must be replaced. Refer to Removing the
Blades and Installing the Blades.
A blade that is bent or damaged could break
apart and could seriously injure or kill you or
bystanders.
• Always replace bent or damaged blade with
a new blade.
• Never file or create sharp notches in the
edges or surfaces of blade.
Removing the Blades
Replace the blades if you hit a solid object or if the
blades are out of balance or bent. To ensure optimum
performance and continued safety conformance of
the machine, use genuine Toro replacement blades.
Replacement blades made by other manufacturers may
result in non-conformance with safety standards.
1. Hold the blade bolt with a wrench.
2. Remove the nut, blade bolt, curved washer, blade,
spacers, and thin washer from the spindle (Figure 48).
39