Toro 30696, Руководство оператора

Страница: 37 / 48

The PTO engagement linkage adjustment is located
beneath the front left hand corner of the engine deck.
1. Disengage the blade control (PTO) lever and set the
parking brakes.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Engage the blade control lever (PTO).
4. Adjust the linkage length to where the lower end
of the bellcrank just clears the axle support gusset
(Figure 42).
Figure 42
1. Bellcrank 4. Yoke
2. Safety switch located
under engine deck 5. Nut
3. Bellcrank just clears the
gusset with the PTO
engageded 6. Assist arm link
5. Make sure the assist arm is against the rear assist arm
stop on the deck (Figure 43).
6. Push the blade control lever (PTO) down to the
disengaged position.
7. The assist arm should contact the front assist arm
stop on the deck. If it does not contact, adjust the
bellcrank so it is closer to the gusset (Figure 43).
Figure 43
1. Assist arm 3. Rear assist arm stop
2. Front assist arm stop 4. Turnbuckle
8. To adjust the assist arm link, remove the hairpin
cotter pin from the assist arm (Figure 43).
9. Loosen the nut against the yoke (Figure 42).
10. Remove the assist arm link from the assist arm and
rotate the link to adjust the length.
11. Install the assist arm link into the assist arm and
secure it with the hairpin cotter pin (Figure 43).
12. Check if the assist arm hits against the stops
correctly.
Adjusting the PTO Safety Switch
1. Disengage the blade control (PTO) lever and set the
parking brakes.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Disengage the blade control lever (PTO). Make sure
the assist arm is against the front assist stop arm.
4. If needed, adjust the blade safety switch by loosening
the bolts holding the switch bracket (Figure 44).
5. Move the mounting bracket until the bellcrank
depresses the plunger by a 1/4 inch (6 mm).
6.
Note:
Make sure the bellcrank does not touch the
switch body or damage to the switch could occur
(Figure 44).
Tighten the switch mounting bracket.
37