41
MAINTENANCE
ADJUSTING WINGLET STABILIZERS
If front winglet decks bounce excessively when in
transport, an adjustment to the winglet stabilizers is
required.
1.
Park machine on a level surface, engage parking
brake, lower front deck completely to the ground and
turn the engine OFF.
2.
Loosen capscrews securing winglet stabilizer
brackets to deck and move brackets outward.
Figure 70
1. Winglet stabilizer brackets
3.
Start engine and raise front deck completely, then
stop engine.
4.
Move stabilizer brackets inward until rollers
contacts skirt of machine, then tighten capscrews
locking adjustment.
TRACTION CONTROL NEUTRAL
ADJUSTMENT
If machine moves when traction pedal and pump lever
are in neutral position, adjustment is required.
1.
Park machine on a level surface, engage parking
brake, raise wing decks completely, lower front deck to
the ground and turn the engine OFF.
2.
Actuate pump lever (with foot pedal) to make sure
that foot pedal and linkage operate freely. Correct if
necessary.
3.
Put blocks at front and rear of all four wheels.
Disengage the two (2) planetary wheel drives; refer to
Pushing or Towing Machine, page 23.
CAUTION
Failure to put machine on a level surface,
block wheels and disengage planetary
wheel drives before doing neutral adjust
ment procedure could result in personal
injury from machine movement.
4.
With engine OFF, loosen nut on carriage bolt and
allow bearing to locate cam (Fig. 71). Carefully tighten
nut on carriage bolt.
Figure 71
1. Screws
2. Neutral Device Bracket
3. Cam
4. Neutral Switch
5. Carriage Bolt
6. Bearing
5.
Loosen screws to allow neutral device bracket to
move; but not freely (Fig. 71). Adjust neutral device
bracket so that 40+ in-lb of torque on control lever just
starts to rotate lever. Tighten screws.
6.
Adjust neutral switch; refer to Traction (Neutral)
Switch Replacement and Adjustment, page 41.
7.
Adjust Traction Control Rod; refer to Traction
Control Rod Adjustment, page 42.
8.
If movement is still evident when traction pedal and
pump lever are in neutral contact your local authorized
TORO Distributor for assistance.
TRACTION (NEUTRAL) SWITCH
ADJUSTMENT
1.
Make sure traction pedal is in neutral position.
Loosen jam nut on switch adjusting screw (Fig. 72).
2.
Rotate adjusting screw toward switch until circuit
through switch is made.
3.
Rotate adjusting screw an additional 1 turn.
Tighten jam nut.
Figure 72
1. Traction (neutral) Switch 2. Adjusting Screw
3.
Actuate traction pedal in both FORWARD and
REVERSE to assure that switch clicks" in both
directions.
