31
MAINTENANCE
Figure 42
1. Alternator
1
D. Install panel and close hood.
5.
Every 100 hours operation, check condition of
cooling system hoses and tightness of connections.
Repair, as needed.
6.
Every 1000 hours, or yearly, drain and flush the
cooling system and replace the thermostat and hose
assemblies.
GENERAL AIR CLEANER MAINTENANCE
1.
Check air cleaner body for damage which could
possibly cause an air leak. Replace a damaged air
cleaner body.
2.
Service the air cleaner filter every 200 hours (more
frequently in extreme dusty or dirty conditions).
SERVICING AIR CLEANER
1.
Release latches securing air cleaner cover to air
cleaner body. Separate cover from body. Clean inside
of air cleaner cover.
1. Air cleaner latches
2. Cover
Figure 43
1
2
2.
Gently slide filter out of air cleaner body to reduce
the amount of dust dislodged. Avoid knocking filter
against air cleaner body.
1. Air cleaner filter
Figure 43
1
3.
Inspect filter and discard if damaged. Do not wash
or reuse a damaged filter.
Washing Method
A. Prepare a solution of filter cleaner and water
and soak filter element about 15 minutes. Refer to
directions on filter cleaner carton for complete
information.
B. After soaking filter for 15 minutes, rinse it with
clear water. Maximum water pressure must not
exceed 40 psi to prevent damage to the filter
element. Rinse filter from clean side to dirty to side.
C. Dry filter element using warm, flowing air
(160
F ) max), or allow element to air-dry. Do not
use a light bulb to dry the filter element because
damage could result.
Compressed Air Method
A. Blow compressed air from inside to the outside
of dry filter element. Do not exceed 100 psi to
prevent damage to the element.
B. Keep air hose nozzle at least 2" from filter and
move nozzle up and down while rotating the filter
element. Inspect for holes and tears by looking
through the filter toward a bright light.
5.
Inspect new filter for shipping damage. Check
sealing end of filter. Do not install a damaged filter.
6.
Insert new filter properly into air cleaner body.
Make sure filter is sealed properly by applying pressure
to outer rim of filter when installing. Do not press on
flexible center of filter.
7.
Reinstall cover and secure latches.
