15
Installing the New Decal
Parts needed for this procedure:
1
Decal, danger
Procedure
Install the Danger Decal (Part Number 66-1340 or
93-7824 for CE) on the front edge of the deck, inside
the right castor arm.
16
Mounting the Blower
Housing Chute
Parts needed for this procedure:
1
Chute assembly
Procedure
Important:
When the chute in the Blower Kit is
used with a 15 cubic foot Hopper Kit, you must
cut off a section of the chute to ensure proper fit
between the blower and the hopper. If used with
another kit, proceed to step 3.
1.
Using the dimensions shown in
, use a
tape measure and mark the chute.
Note:
For convenience, some chutes may have
a light scribe mark where the chute must be cut
off.
g012554
Figure 28
1.
61.2 cm (24.12 inches)
2.
70.5 cm (27.75 inches)
2.
Draw lines around all sides of the chute and cut
off with a saw.
3.
Set the deck to the desired height-of-cut setting.
4.
Slide the chute over the blower opening and
onto the mounting studs (
g012555
Figure 29
1.
Chute
2.
Chute brackets
5.
Lower the hopper hood and align the chute with
the hood snout. Secure the chute in position
with 4 locknuts (5/16 inch) and chute brackets.
Position the wide end of brackets to the rear.
14
