Toro 30484, Руководство оператора

Страница: 40 / 60

Figure 53
1. Hydraulic pumps
5. Clutch wire connector
2. Idler pulley 6. Pivot bolt
3. Clutch retainer
7. Drive pulley
4. Tension spring 8. Pump drive belt
7. Unhook the idler spring from the frame (Figure 53).
8. Install the new belt around clutch and the two drive
pulleys.
9. Install the idler spring between idler arm and frame
bracket (Figure 53).
10. Install the clutch retainer to the engine deck
(Figure 53).
11. Connect the clutch wire connector to the wire
harness.
12. Install the PTO drive belt.
Controls System
Maintenance
Adjusting the Motion Control
Handle Positions
Adjusting the Right Side Motion Control
Lever
If the motion control levers do not align horizontally,
adjust the right side motion control lever.
Note:
Adjust the horizontal alignment before the front
to back alignment.
1. Disengage the PTO, move the right side motion
control lever to the neutral position and set the
parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Push the right motion control lever down out of
locked neutral position (Figure 54).
4. Check if it aligns horizontally with the left motion
control lever (Figure 54).
Figure 54
1. Left motion control lever 3. Check the horizontal
alignment here
2. Right motion control lever
in neutral locked position 4. Right motion control lever
5. To adjust the right motion control lever horizontally,
the cam needs to be adjusted.
6. Remove the cover under the control panel.
7. Loosen the nut and bolt holding the cam (Figure 55).
8. Adjust the cam until it aligns with the left motion
control lever and tighten the nut and bolt for the
cam.
40