Toro 30484, Руководство оператора

Страница: 19 / 60

1. Select hole in height-of-cut post and number of
spacers corresponding to the height-of-cut desired
(Figure 14).
2. Using the lift handle, raise side of deck and remove
hairpin cotter (Figure 14).
3. Add or remove spacers if needed and then align
holes and insert hairpin cotter (Figure 14).
Note:
Spare height-of-cut spacers may be stored
on posts and retained by a hairpin cotter.
Important:
All four hairpin cotter pins must be
in the same hole location and with the correct
number of spacers for a level cut.
Figure 14
1. Carrier Frame 4. Spacers
2. Hairpin Cotter 5. Front height-of-cut post
3. Back height-of-cut post
Adjusting the Anti-Scalp
Rollers
The anti-scalp rollers need to be adjusted in the proper
hole location for each height-of-cut position. There
needs to be 3/8 inch (10 mm) minimum clearance
above the ground.
Note:
If the anti-scalp rollers are adjusted too low it
can cause excess wear of the rollers.
1. After adjusting height-of-cut, check the anti-scalp
rollers so that there is a minimum of 3/8 inch
(10 mm) clearance above the ground (Figure 15,
Figure 16, Figure 17).
2. If adjustment is needed, remove the bolt, washers
and nut (Figure 15, Figure 16, Figure 17).
3. Select a hole position so the anti-scalp rollers are
a minimum of 3/8 inch (10 mm) off the ground
(Figure 15, Figure 16, Figure 17).
4. Install the bolt and nut (Figure 15, Figure 16,
Figure 17).
Figure 15
40 inch, 48 inch, and 52 inch Mower Decks
1. Mower deck 4. Anti-Scalp Rollers
2. Bolt 5. Nut
3. Spacer
19